Free Service Hotline:

0086-18029123978

Other Intelligent Production Lines

View Categories

Leak Test Line for One-piece ToiletReturn

Because the one-piece toilet is heavier, it is suitable for choosing to do automatic assembly line conveying, which must be made of single-layer work plate or upper and lower rotating work plate.


Its line body is made of high-strength aluminum profile, the work plate conveying chain adopts BS30-C212A triple speed chain, the power adopts frequency conversion speed control, and the blocker adopts cylinder automatic blocking.



Leak Test Line for One-piece Toilet
  • Product Details
  • Product Specifications

Other additional configurations are lighting, process card, hanging rail, instrument table, air pipe, socket, jacking shift, parallel shift, water faucet and so on, which can be configured according to customer's requirements.


Assembly Line for One-piece Toilet Parts

This assembly line workbench is composed of heated small plate workbench, key assembly workbench, cleaner assembly workbench, distribution valve testing workbench and seat workbench. The table plate is made of plywood with green rubberized skin. The multiplier chain line is used as the parts transfer line between the workstations, which well connects the work processes between the workstations and saves manpower time.


Leak Test Line for One-piece Toilet


1. Measure the toilet and the installation position to ensure that the product size is correct and convenient to use. Install the triangle valve, and check whether the ground under the water is clean and free of foreign matter.


2. Put the toilet into the position to be installed and align the drain. Use a pencil to draw a line along the edge of the toilet, make it clear that the exact position after installation so as to facilitate the application of silicone fixation.


3. Check the quality of the flange and place it in the waste opening. Fix it with silicone and make sure that no leakage and other problems will occur. Flange installation is the most important part of the whole process.


4. Set the toilet back in its original position, make sure the position is fixed, you should clean up the overflowing silicone at the bottom in time. Repair the place where there is no fit to prevent future leakage.


5. Connect the toilet water inlet hose. To ensure that the connection point is firm, the tube body without folding pressure, to ensure that water seepage, leakage or poor water flow will not occur in the future.


Toilet seat after installation should be aligned with the water discharge test, properly adjust the water level in the tank high and low, through the sound, flow rate to check whether the water is smooth and normal.


Related product recommendations

<
  • LED aging line

  • Pallet Lift

  • 全自动晶圆Frame贴膜机

  • Multi-Level Lift

  • Bucket Elevator

  • Cabinet type high-temperature oven

  • Automatic Assembly Line for Solar Inverter

  • Refrigerator assembly line

  • Integrated Automation Solutions

  • Automatic Production Line for New Energy Battery PACK

  • Injection Machine for Bluetooth and Digital Batteries

  • Automatic Assembly Line for Charging Pile

  • PCB Waterproof Laser Degumming Intelligent Equipment

  • Automatic Ultrasonic Welding Machine for Square Aluminum Shell Electric Core

  • Lithium battery packaging production line

>